Otherwise, there is a good chance that you could run the system out of PTEs.
After doing so, click the icon to access the Add Counters dialog box, shown in Figure.Therefore, I want to show you up front how to change the pagefile size.If any of these counters exceed their threshold values then you should add some memory to the server and increase the size of the pagefile.Just below the listing of the system's volumes is an area for you to set the minimum and maximum page file sizes.X86 client versions with PAE enabled do have a usable 37-bit (128 GB) physical address space.Limits greater than 4 GB for 32-bit Windows assume that PAE is enabled.
By default, Windows uses something called the 2 GB memory model.
You have probably seen at least one situation in which a system's hard disk was running constantly with no visible results and a very sluggish response time.
Figure C, you should start by monitoring the Memory / Available Bytes and the Paging File / Usage counters.If you look at the figure, you will notice that all of my system's drives are listed, but that the page file exists on the C: windows 7 winpe iso volume.Windows Vista: Limited only by kernel mode virtual address space.Windows Server 2003 and Windows XP: Up to 1 TB depending on configuration and RAM.Physical Memory Limits: Windows 10 The following table specifies the limits on physical memory for Windows 10.Once you add these counters, the Performance Monitor will look something like what you see in Figure.On the flip side, if only about 20 or less of the page file is in use then you are probably wasting system resources with an unnecessarily large page file.